Just like any other product, Teds Wood Working is not perfect, nor is it the ultimate woodworking resource out in the market. With its sheer number of plans, you are bound to find a few plans that will not appeal to some users. However, unsatisfied customers are always free to request for refunds. Delays in meeting customer complaints may vary from one location to another, but most customer complaints are eventually resolved with the ultimate goal of ensuring customer satisfaction.
There is lawn furniture, and then there is what you might call landscape furniture—custom seating built right into the terrain. Done right, it can create a little oasis in your yard or even on your deck. Take, for instance, this bench with planters for piers. The entire structure is made from rot- and weather-resistant cedar lumber. It was built using lap joinery, a sturdy construction method meant to keep the planter walls from bowing against pressure from roots, should you decide to plant trees.
While many customers are satisfied that they have a go-to resource for woodworking plans, not all will find all the plans helpful and others may think that they can get better quality videos and instructions from other sources. It all depends on what you are looking for and how willing you are to spend money on the right woodworking resources. Whether you find that this product meets your needs or not, it is always important to do your due diligence when purchasing this or any other product.

We have helped thousands of general and specialty contractors of all types build stronger, more profitable businesses. Sign up for our free newsletter and receive advice and encouragement for your business. We offer affordable DVD training in estimating, sales and business management, along with estimating and proposal writing software that doesn’t cost an arm and a leg. Free Online Catalog for US addresses only.


Begin by cutting off a 10-in. length of the board and setting it aside. Rip the remaining 38-in. board to 6 in. wide and cut five evenly spaced saw kerfs 5/8 in. deep along one face. Crosscut the slotted board into four 9-in. pieces and glue them into a block, being careful not to slop glue into the saw kerfs (you can clean them out with a knife before the glue dries). Saw a 15-degree angle on one end and screw the plywood piece under the angled end of the block.

×